Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws on the base cover.
Remove the screws that secure the base cover to the palm rest and keyboard assembly.
Using a plastic scribe, moving in an anti-clockwise direction beginning from the top left corner, pry the base cover.
Lift the base cover off the palm rest and keyboard assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Memory Modules
Identify the memory modules highlighted in blue.
Peel back the mylar to access the memory module.
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory Modules
Identify the memory modules location highlighted in blue.
Peel back the mylar to access the memory module.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Place the base cover on the palm rest and keyboard assembly, and snap the base cover into place.
Install the screws that secure the base cover to the palm rest and keyboard assembly.
Tighten the screws that secure the base cover to the palm rest and keyboard assembly.