Removal
Base Cover
Identify the base cover highlighted in blue.
Using a Torx #5, remove the screws that secure the base cover.
Starting at the bottom left corner, carefully pry the base cover along the bottom and sides.
Grasp the bottom and rotate it upwards to release the base cover from the system.
Battery Cable
Identify the battery cable highlighted in blue
Use the tab to assist in disconnecting the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Unroute the WLAN antennas from the routing guides on the battery.
Remove the screws that secure the battery.
Slightly lift the battery at an angle and slide to remove from the system
Speakers
Identify the speaker highlighted in blue.
Use the tabs to disconnect the left and right speaker cables from the system board.
Peel the left and right tweeter speakers from the slots on the system
Unroute the tweeter speakers cables from the routing guides on the system board.
Remove the screws that secure the speakers to the system
Lift to remove the left and right speakers from the system
Smart-card reader
Identify the smart card reader highlighted in blue.
Lift the latch and disconnect the smart card reader cable from the USH board.
Peel the smart card reader cable from the palmrest.
Remove the screws that secure the smart card reader to the system
Slide and lift to remove the smart card reader.
Install
Smart-card reader
Identify the smart card reader location highlighted in blue.
Align and place the smart card reader into the slot on the palm rest.
Install the screws to secure the smart card reader in place.
Adhere the smart card reader cable to the palmrest.
Connect the smart card reader cable to the USH board.
Speakers
Identify the speaker location highlighted in blue.
Align and install the left and right speakers into the slots on the system.
Replace the screws that secure the left and right speakers to the system
Connect the speaker cables to the system board.
Route the tweeter speakers cables using the routing guides on the system board.
Adhere the tweeter speakers into the slots on the system.
Battery
Identify the battery location highlighted in blue.
Install the battery and align the screw holes.
Install the screws that secure the battery.
Route the WLAN antennas using the routing guides on the battery.
Battery Cable
Identify the battery cable highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Align the base cover and press the edges of the cover until it clicks into place.
Install the screws that secure the base cover. (requires Torx #5)