Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release button, and pull the left end of the front bezel.
Unhook the right end, and remove the front bezel.
Air Shroud
Identify the air shroud highlighted in blue
Holding the blue touch points, apply firm pressure to remove the air shroud.
VGA module
Identify the VGA module highlighted in blue
Disconnect the VGA cable from the VGA connector on the system board.
Remove the screws on the VGA module.
Slide the module out of the system until it is free of the VGA module slot on the front panel.
Install
VGA module
Identify the VGA module location highlighted in blue
Route the VGA cable on the VGA module, through the VGA slot on the front panel.
Insert the VGA module into the slot on the front panel.
Replace the screw to secure the module to the system
Route the VGA cable and connect it to the VGA connector on the system board.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
Front Bezel
Identify the front bezel location highlighted in blue
Hook the right end of the front bezel onto the system.
Fit the free end of the front bezel onto the system.
Lock the front bezel by using the key.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.