How to replace the Optional OCP card on a PowerEdge C6620

This 3D experience gives you the step by step process of replacing the Optional OCP card and a PowerEdge C6620. The procedure will also include removing the Expansion card riser 1, Expansion card riser 2 and reinstalling them.

Removal

Expansion card riser 1

Identify the riser highlighted in blue.

Using a phillips #1 screwdriver, remove the screws that secure the expansion card riser 1.

Holding the handle, lift the expansion card riser from the riser connector on the system board.

Expansion card riser 2

Identify the riser highlighted in blue.

Using a phillips #1 screwdriver, remove the screws that secure the expansion card riser 2.

Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.

Optional OCP card

Identify the optional OCP card highlighted in blue.

Lift the OCP card retention latch.

Disengage the OCP card and remove it from the sled.

Install

Optional OCP card

Identify the optional OCP card location highlighted in blue.

Lift the OCP card retention latch.

Align and insert the OCP card into the sled. Slide the OCP card and push firmly until it is fully connected to the system board connector.

Close the OCP card retention latch to secure the card in place.

Expansion card riser 2

Identify the riser location highlighted in blue.

Lower the riser card firmly until the riser card is fully seated in the slot.

Using a phillips #1 screwdriver, install the screws that secure the expansion card riser 2 on to the system board.

Expansion card riser 1

Identify the riser location highlighted in blue.

Lower the riser firmly until the riser card is fully seated in the slot.

Using a phillips #1 screwdriver, install the screws that secure the expansion card riser 1 on to the system board.