Removal
Base Cover
Identify the base cover highlighted in blue.
Remove the screws that secure the base cover.
Loosen the captive screws that secure the base cover.
Using your fingertips, pry the base cover from the middle of the front edge and around the sides to release the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Carefully pull the tape to disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Memory modules
Identify the memory module highlighted in blue.
Lift the mylar cover to access the memory slots.
Using your fingertips, carefully spread apart the securing clips until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory modules
Identify the memory module location highlighted in blue.
Lift the mylar cover to access the memory slots.
Align the notch with the tab and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable location highlighted in blue
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide the notches under the rear I/O-cover and snap the base cover into place.
Install the screws that secure the base cover to the system.
Tighten the captive screws that secure the base cover.