Removal
Base Cover
Align the system with the outline to enable the AR lock.
Loosen the captive screws that secure the base cover to the system
Pry open the base cover from the smart-card reader slot at the bottom right side of the base cover.
Lift the base cover starting from the bottom edge and remove it from the system.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Remove the screws that secure the battery to the system.
Lift the battery from the system.
Install
Battery
Identify the battery location highlighted in blue.
Insert the battery into the slot on the system.
Install the screws to secure the battery to the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide the base cover into its slot until it clicks into place.
Tighten the captive screws to secure the base cover to the system.