Removal
Base Cover
Align the system with the outline to enable the AR lock.
Identify the base cover highlighted in blue.
Slide the blue tab to release the base cover from the system.
Slide the cover toward the back and lift to remove from the system.
Front Bezel
Identify the front bezel highlighted in blue.
Lift the tabs to release the bezel from the system.
Slightly lift the front of the system to release the bezel from system.
Front Panel
Identify the front panel highlighted in blue.
Lift the front panel up to open.
PSU
Identify the power supply unit (PSU) highlighted in blue.
Disconnect the PSU cables from the system board and unroute from the retention clips.
Remove the screws that secure the PSU to the system.
Press the blue tab to release the PSU.
Slide the PSU outwards and lift up to remove it from the system.
Install
PSU
Identify the power supply unit (PSU) location highlighted in blue.
Lower the PSU into the slot and slide it toward the back until it clicks into place.
Route the PSU cables through the retention clips and connect them to the system board.
Install the screws to secure the PSU to the system.
Front Panel
Identify the front panel highlighted in blue.
Close the front panel door. Push down until it clicks into place.
Front Bezel
Identify the front bezel location highlighted in blue
Align the tab holders on the system and push the bezel until the tabs click into place.
Base Cover
Identify the base cover location highlighted in blue.
Install the cover on the system and slide it until it clicks into place.
Slide the blue tab to lock the cover to the system.