Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Drive Backplane.Assembly
Identify the hard drive backplane highlighted in blue
Slide and lift the backplane cover in the direction of the arrows marked on the backplane cover.
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
Disconnect the cables from the backplane.
Disconnect the cable from the rear mount front PERC module.
Press the blue release tabs and lift the backplane to disengage the backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Rear Mounting Front PERC Module
Identify the Front PERC module highlighted in blue.
Loosen the captive screws on the front PERC module.
Slide the front PERC module to disengage from the connector on the drive backplane.
Install
Rear Mounting Front PERC Module
Identify the Front PERC module location highlighted in blue.
Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
Slide the front PERC module until the module is connected to the drive backplane.
Tighten the captive screws on the front PERC module.
StepInfoTxt
Drive Backplane.Assembly
Identify the hard drive backplane location highlighted in blue
Use the guides on the system as guides to align the slots on the backplane.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
Connect the cable to the rear mount front PERC module.
Connect the cables to the backplane.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Slide the backplane cover toward the front of the system until the cover locks into place.
Air shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.