Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell Chassis Management Controller Version 3.0 for Dell EMC PowerEdge VRTX User's Guide

PDF

Configuring Multiple CMCs Using RACADM

Using RACADM, you can configure one or more CMCs with identical properties.

When you query a specific CMC card using its group ID and object ID, RACADM creates the racadm.cfg configuration file from the retrieved information. By exporting the file to one or more CMCs, you can configure your controllers with identical properties in a minimal amount of time.

NOTE Some configuration files contain unique CMC information (such as the static IP address) that must be modified before you export the file to other CMCs.
  1. Use RACADM to query the target CMC that contains the desired configuration.
    NOTE The generated configuration file is myfile.cfg. You can rename the file. The .cfg file does not contain user passwords. When the .cfg file is uploaded to the new CMC, you must re-add all passwords.
  2. At the command prompt, type: 
    racadm getconfig -f myfile.cfg
    NOTE Redirecting the CMC configuration to a file using getconfig -f is only supported with the remote RACADM interface.
  3. Modify the configuration file using a plain-text editor (optional). Any special formatting characters in the configuration file may corrupt the RACADM database.
  4. Use the newly created configuration file to modify a target CMC. At the command prompt, type: 
    racadm config -f myfile.cfg
  5. Reset the target CMC that was configured. At the command prompt, type: 
    racadm reset

    The getconfig -f myfile.cfg subcommand requests the CMC configuration for the active CMC and generates the myfile.cfg file. If required, you can rename the file or save it to a different location.

    You can run the getconfig command to perform the following actions:
    • Display all configuration properties in a group (specified by group name and index).
    • Display all configuration properties for a user by user name.

    The config subcommand loads the information into other CMCs. The Server Administrator uses the config command to synchronize the user and password database.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\