- Notes, cautions, and warnings
- Working on your computer
- Removing and
installing components
- Recommended tools
- Back cover
- Front Bezel
- Opening the front panel door
- Storage
- Removing 3.5–inch hard drive assembly
- Removing 3.5–inch hard drive from the hard drive bracket
- Installing the 3.5–inch hard drive into the hard drive bracket
- Installing 3.5–inch hard drive assembly
- Removing the 2.5–inch drive assembly
- Removing the 2.5–inch drive from the drive bracket
- Installing the 2.5–inch hard drive into the hard drive bracket
- Installing the 2.5-inch drive assembly
- Optical drive
- M.2 PCIe SSD
- SD card reader
- Memory module
- Expansion card
- Power supply unit
- VGA daughter board
- Intrusion switch
- Power switch
- Speaker
- Coin cell battery
- Heat sink assembly
- Processor
- System fan
- System board
- M.2 Intel Optane Memory Module 16 GB
- Technology and components
- System setup
- Software
- Troubleshooting your computer
- Technical specifications
- Processor specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Storage specifications
- Ports and connectors specifications
- Power supply specifications
- Physical dimension specifications
- System board layout
- Controls and lights specifications
- Environmental specifications
- Contacting Dell
OptiPlex 5050 Tower Owner's Manual
Installing optical drive
- Insert the optical drive into the optical drive bay until it clicks into place.
- Open the front panel door.
- Route the data cable and power cable under the drive cage.
- Connect the data cable and power cable to the connectors on the optical drive.
- Close the front panel door.
- Install the:
- Follow the procedure in After working inside your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\