Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T20 Owner's Manual

PDF

Installing an expansion card

  1. Unpack the expansion card and prepare it for installation.
    • NOTE: For instructions, see the documentation accompanying the card.
  1. Push out the expansion card release latch to open it.
  2. If installed, remove the expansion-card filler.

    The steps for installing or removing an expansion-card filler are similar to installing or removing an expansion card.

    • NOTE: You must install an expansion card filler bracket over an empty expansion slot. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  3. Holding the expansion card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
  4. Push the expansion card into the expansion card slot until the expansion card is fully seated.
  5. Push the expansion card latch toward the system until it clicks into place.
  1. If applicable, connect the cables to the expansion card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\