Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T20 Owner's Manual

PDF

Removing an expansion card

  1. Disconnect all the cables from the expansion card.
  1. Press and push out the expansion card release latch.
  2. Holding the card by its edge, pull the card to disengage it from the connector and lift the card out of the chassis.
  3. If you are removing the card permanently, install an expansion card filler in the empty card slot.

    The steps for installing or removing an expansion card filler are similar to installing or removing an expansion card.

    • NOTE: You must install an expansion card filler bracket over an empty expansion slot. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  4. Push the expansion card latch toward the system until it clicks into place.
    Figure 1. Removing and Installing an Expansion Card The figure shows removing and installing an expansion card.
    1. expansion card
    2. expansion-card latch
    3. filler bracket
    Figure 2. Installing the expansion-card filler This figure shows installing the expansion-card filler.
  1. Install the expansion card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\