- Notes, cautions, and warnings
- Copyright
- About your system
- Using The System Setup And Boot Manager
- Installing System
Components
- Recommended Tools
- Opening And Closing The System
- Bezel
- Chassis intrusion switch
- Inside the system
- Thermal Sensor
- Power switch
- Input/Output (I/O) panel
- Hard drives
- Removing the hard drive cage
- Installing the hard drive cage
- Removing a 3.5-inch hard drive carrier from the hard drive cage
- Installing a 3.5-inch hard drive carrier in the hard drive cage
- Removing a 2.5-inch hard drive(s) from the optical drive bay
- Installing a 2.5-inch hard drive(s) in the optical drive bay
- Removing a 3.5-inch hard drive carrier from the hard drive bay
- Installing a 3.5-inch hard drive carrier in the hard drive bay
- Removing A Hard Drive From A Hard-Drive Carrier
- Installing A Hard Drive Into A Hard-Drive Carrier
- Optical drive
- System memory
- Sample memory configurations
- System fan
- Expansion cards
- Processors
- Power supply unit
- System Battery
- System board
- Troubleshooting
your system
- Power LED Diagnostics
- Memory Beep Code
- Troubleshooting System Startup Failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial I/O device
- Troubleshooting A NIC
- Troubleshooting A Wet System
- Troubleshooting A Damaged System
- Troubleshooting the system battery
- Troubleshooting A Non-Redundant Power Supply
- Troubleshooting cooling problems
- Troubleshooting The System Fan
- Troubleshooting System Memory
- Troubleshooting An Optical Drive
- Troubleshooting A Hard Drive
- Troubleshooting Expansion Cards
- Troubleshooting The Processor
- Using System Diagnostics
- Jumpers and connectors
- Technical Specifications
- System Messages
- Getting help
Dell PowerEdge T20 Owner's Manual
Installing the system board
- CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or system setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives.
- Unpack the new system board assembly.
- Install the following:
- heat sink and processor
- memory modules
- expansion cards
- system fan
- Connect all cables to the system board.
- Enter the system service tag after you install the system board. For more information about entering the service tag, see the Entering The Service Tag After Replacing The System Board section.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\