Dell Storage Center SCv2000 and SCv2020 Storage System Deployment Guide

For a Storage Center with iSCSI front-end ports, use the Configure Fault Tolerance page and the Fault Domain pages to enter network information for the fault domains and ports.

1. (Optional) On the Configure Fault Tolerance page, click More information about fault domains or How to set up an iSCSI network to learn more about these topics.
2. Click Next.
   • NOTE: If any iSCSI ports are down, a dialog box appears that allows you to unconfigure these ports. Unconfiguring the down iSCSI ports will prevent unnecessary alerts.
3. On the Configure iSCSI HBA Fault Domain 1 page, enter network information for the fault domain and its ports.
   • NOTE: Make sure that all the IP addresses for iSCSI Fault Domain 1 are in the same subnet.
4. Click Next.
5. On the Configure iSCSI HBA Fault Domain 2 page, enter network information for the fault domain and its ports. Then click Next.
   • NOTE: Make sure that all the IP addresses for iSCSI Fault Domain 2 are in the same subnet.

6. Click Next.