Dell Storage Center SCv2000 and SCv2020 Storage System Deployment Guide

Configure a localhost to access block-level storage on the Storage Center. It is recommended that you perform this procedure for each host that is connected to the Storage Center.

1. On the Configuration Complete page of the Discover and Configure Storage Center wizard, click Set up block level storage for this host. The Set up localhost for Storage Center wizard appears.
   • If the Storage Center has iSCSI ports and the host is not connected to any interface, the Log into Storage Center via iSCSI page appears. Select the target fault domains, and then click Log In.
   • In all other cases, the Verify localhost Information page appears. Proceed to the next step.
2. On the Verify localhost Information page, verify that the information is correct. Then click Create Server. The server definition is created on the Storage Center for the connected and partially connected initiators.
3. The Host Setup Successful page displays the best practices that were set by the wizard and best practices that were not set. Make a note of any best practices that were not set. It is recommended that these updates be applied manually before starting IO to the Storage Center.
4. (Optional) Select Create a Volume for this host to create a volume after finishing host setup.
5. Click Finish.