Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell Chassis Management Controller Version 2.0 for PowerEdge FX2 and FX2s User's Guide

PDF

Configuring Management Port 2 using CMC web interface

To configure Management Port using CMC Web Interface:
  1. In the left pane, click Chassis Overview > Network, and then click the Network tab.
  2. On the Network Configuration page, in the General Settings section, next to Management Port 2, select either Redundant or Stacking.
  3. Click Apply Changes.
    • When Management Port 2 is set for Redundant but is cabled for Stacking, the downstream CMCs (further from the top-of-rack switch) does not have a network link.
    • When Management Port 2 is set for Stacking but is cabled for Redundant (two connections to the TOR switch), routing loops could cause a network storm.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\