Dell Chassis Management Controller Version 2.0 for PowerEdge FX2 and FX2s User's Guide

PDF

Verifying FlexAddress activation

To view the FlexAddress feature activation status, run the following RACADM command:

racadm featurecard -s

       Feature Name = FlexAddress             
       Date/time Activated = 05 Oct 2013 - 11:50:49  
       Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

       Feature Name = FlexAddressPlus         
       Date/time Activated = 05 Oct 2013 - 11:50:49  
       Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

       Feature Name = ExtendedStorage
       Current Status = redundant, active
       Date/time Activated = 05 Oct 2013 - 11:50:58
       Feature installed from SD-card serial number = CN0H871T1374036T00MXA00

If there are no active features on the chassis, the command returns a message: racadm feature -s No features active on the chassis

racadm feature -s 
No features active on the chassis

To view the SD card information:

$ racadm featurecard -s
Active CMC:
The feature card inserted is valid, serial number CN0H871T1374036T00MXA00
The feature card contains the following feature(s)
 FlexAddress: bound
 FlexAddressPlus: bound
 ExtendedStorage: bound

Table 1. Status Messages Returned by the featurecard -s CommandThe following table contains messages returned by the featurecard —s command.
Status Message	Actions
No feature card inserted.	Check CMC to verify that the SD card was properly inserted.
The feature card inserted is valid and contains the following feature(s) FlexAddress: bound.	No action required.
The feature card inserted is valid and contains the following feature(s) FlexAddress: bound to another chassis, svctag=ABC1234, SD card SN = 1122334455.	Remove the SD card; locate and install the SD card for the current chassis.
The feature card inserted is valid and contains the following feature(s) FlexAddress: not bound.	The feature card can be moved to another chassis or can be reactivated on the current chassis. To reactivate on the current chassis, enter racadm racreset until the CMC module with the feature card installed becomes active.

Dell Feature Cards may contain more than one feature. Once any feature included on a Dell Feature Card has been activated on a chassis, any other features that may be included on that Dell Feature Card cannot be activated on a different chassis. In this case, the racadm feature -s command displays the following message for the affected features:

ERROR: One or more features on the SD card are active on another chassis

For more information on the feature and featurecard commands, see the Dell Chassis Management Controller for PowerEdge FX2/FX2s RACADM Command Line Reference Guide.