Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell Wyse ThinLinux 1.0.3 Administrator’s Guide

PDF

EAP-PEAP (MSCHAPv2) — User authentication

To authenticate 802-1x by using an Active Directory username account:
  1. Turn on your thin client device. After the INI is downloaded to the thin client, you can access the domain that is configured in the INI from the domain drop-down list on the GDM Login screen.
  2. On the GDM login screen, select the domain, and then enter the user domain credentials.
  3. Click Log in. The 802-1 authentication automatically starts.
    • NOTE: The GDM Authentication module performs the Network Manager configuration required for 802-1x PEAP (MSCHAPv2) authentication by using the credentials entered and 802-1x configurations from INI. Then, it reinitializes the network to do a direct 802-1x authentication with the switch.
    • If log in is successful, then the thin client gets IP address from the protected VLAN and you can start the local thin client session (GNOME session). You can also start RDP, ICA, PCOIP sessions using the same domain credentials provided in the GDM login. These credentials will be preexisting in the connection manager, and you need not renter the same again.
      • NOTE:
        • If you set Is802DirectEnabled=yes, the direct authentication is enabled which will trigger the 802-1x authentication from the GDM login screen. In this case the ActiveDirectoryServer parameter is not required.

        • If you set Is802DirectEnabled=no, the 802-1x authentication is triggered after the user logs in to the thin client. In this case you need to include the ActiveDirectoryServer parameter in the INI.

    • If log in is unsuccessful, the 802-1x authentication fails and the thin client remains in the Guest VLAN.

  4. When you log out or restart the device, thin client will again move to Guest VLAN by sending an EAPOL logoff to switch and disabling the 802-1x configuration at Network Connections applet.
The following is an example of the INI configuration for EAP-PEAP (MSCHAPv2) 802-1x User authentication.
For AD and Domain settings 
DomainList=npac.local DisableDomain=no

For Imports Certficates 

ImportCerts=no

For 802-1x Configuration

Enable802=yes Authentication=PEAP InnerAuthentication=MSCHAPv2 PromptPassword=no AuthMode=User Is802DirectEnabled=yes CACertificate=SCEP PeapVersion=Auto

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \