Dell OpenManage Deployment Toolkit Version 4.3 User's Guide

Running RACCAP.BAT Or raccap.sh

To run the RACCAP.BAT or raccap.sh sample script to capture the RAC configuration information in the raccfg.ini file:

Edit the startnet.cmd file (on your Windows PE image) or start-up script file (on your embedded Linux image) to call the RACCAP.BAT or raccap.sh script after the network share with the pre-built DTK directory structure is mounted. For example, add: On systems running Windows:
```
Z:\Dell\x32\Toolkit\Template\Scripts\RACCAP.BAT Z:\raccfg.ini
```
On systems running Linux:
```
/opt/dell/toolkit/template/scripts/raccap.sh
```
Boot the source system into Windows PE or embedded Linux. The script runs and saves the configuration information in the \Toolkit\Systems\<target system> directory on systems running Windows and /opt/dell/toolkit/systems/<target system> directory on systems running Linux.
Edit the startnet.cmd file (Windows PE image) or start-up script file (embedded Linux image) to remove the text you added in step 1.
- NOTE: The RAC configuration file is referred to as the .cfg file in the Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise for Blade Servers User Guide and the Dell Remote Access Controller 4 User’s Guide . See these guides for additional information about manually creating a RAC configuration file.
- NOTE: Do not replicate the RAC IP address when creating a .cfg file. Replicating the RAC IP address can leave the system inaccessible because multiple systems are configured with the same IP address.
- NOTE: On Dell PowerEdge 9G or later systems, raccap.sh and syscap.sh have duplicate functions. If you run raccap.sh followed by syscap.sh, the latter overwrites the former settings.

Välkommen

Välkommen till Dell

Dell OpenManage Deployment Toolkit Version 4.3 User's Guide

Running RACCAP.BAT Or raccap.sh

Betygsätt det här innehållet