Unsolved
3 Posts
0
1041
October 3rd, 2021 16:00
Aurora R6, no boot after LED blinks
I used to get a blink code saying power supply issue. Replaced it, only to get a motherboard failure code. I replaced that. Now I get constant blinking for about 10 seconds, then a pause. Then two blinks, two blinks and a pause, then just repeats. It never boots. I've replaced the board, twice, power supply, memory and video card. Even the cables. The only thing not changed are literally the case and processor. I can find any other discussions about this, and I'm losing my mind. I've even reset the CMOS.
No Events found!
r72019
8 Professor
•
5.3K Posts
1
October 3rd, 2021 18:00
r72019
8 Professor
•
5.3K Posts
1
October 3rd, 2021 18:00
The Aurora R6 does not have an error code for a PSU issue, are you sure you're looking at the right chart?
You need to count the number of blinks during the 10 second interval to determine the issue. For example, 7 blinks is a CPU failure..
If you're getting 2 blinks I'd try reseating RAM and clearing CMOS.
MarkInTheDark
3 Posts
0
October 3rd, 2021 22:00
I did reseat the memory. I even tried different memory that I knew was compatible. I also cleared the cmos and even tried a new cmos battery. And yes, I was looking at the wrong chart.
I get the two blinks, two blinks..then a long pause and the two-two again. I'll double check the initial blinks in the morning and will update. Thank you!
MarkInTheDark
3 Posts
0
October 4th, 2021 10:00
Update: When I power the unit on, it blinks 15 times, pauses, then two blinks, two blinks then a pause and just continues with that. Two blinks, slight pause two blinks, long pause.