Thanks! and the left one?

i did it! i used a screw driver.

Thank you. and the left one?

Chassis Service Manual, page 18, Right Bottom Lower:

That one is trickier:

• Remove pci shroud
• remove the power supply
• remove the farthest forward hard drive fan (Chapter 9: Fans)

Optional step: if you do not remove front panel/bezel & lower grill 1st, you might break the forward clip. The lower grill holds the front panel clip, easily broken if grill is not removed 1st. Super-glue if you break clip.

How to remove front bezel/lower grill:

• remove both side panel doors
• remove pci fan (Chapter 9: Fans)
• remove the front bezel/front panel (Chapter 8)
• remove the lower front grill: screws on bottom, clips on top, released ed from inside
• unplug bottom panel led connector from master i/o
• inspect new panel for clip placements, unclip right bottom panel; back, middle, front

 install new panel; reverse assembly procedures

You tube disassembly video: http://www.youtube.com/watch?v=jgt9IX1ORuM

no prob.

I replaced both lower panels on mine; the mthrbrd side was easy, but I broke the lower grill clip on the hard drive side, because I didn't remove the front bezel/panel & front lower grill 1st.

I had to replace the front lower grill due to this (which meant I had to remove the bezel afterall & was out 6 dollars, lol).

Just be careful if you try this w/out removing front bezel/lower grill. Look at your replacement panel so you know where the clips are & if you can safely replace it w/out removing front bezel/lower grill, yes? Good luck

Thank you!