changed management ip address the wrong way

Hello -

We're running a Clariion CX300 and I needed to change the SPs' IP address. I most likely did it the wrong way and did not heed the warnings about potential issues with the domain.

And now I have absolutely no connectivity to the management interface of the Clariion. The LUN's are still accessible, just the management interface.

I tried to connect to the serial interface of the SAN and was able to connect, but the default ip address (192.168.1.1?) would not respond. Any ideas?

I can shutdown all connected hosts, so if an actual physical reboot is necessary, that's not a problem. Currently the Clariion is in a lab environment, so any type of reconfiguration would be fine - I would just like to fix what I did.

Thanks...

Responses(3)

C

csmykay1

59 Posts

0

November 15th, 2006 12:00

Can you hit the following?

http://old_ip_of_cx/setup?
or
http://new_ip_of_cx/setup?

If not then you will need to get the console access working in order to fix this issue. Do you still have the supplied console cable that ships with the CX?

Shmac

julieg1

305 Posts

0

November 15th, 2006 20:00

There's a Support Solution that might be helpful emc60751 ¿How do I change a storage processor (SP) IP address after it was already set?

Julie Gibson

william.cawthra

2 Posts

0

November 16th, 2006 04:00

Thanks for the suggestions -

it seems I was a bit impatient with the SP's coming back up. All is working on the new IP addresses now.

Apologies if I have wasted any of your time.

View All

No Events found!

CLARiiON

changed management ip address the wrong way