This post is more than 5 years old
36 Posts
0
1244
Cisco switches--9513-- 'tooManyInvaliFLOGIS'
HI all,
I have seen a message when i hold the pointer over the port on the switch a message pops 'tooManyInvalidFLOGIS'.. i did try bringing the port 'admin' UP/Down.. but it did not resolve me... is there anyway to clear this message?
Your help is much appreciated.
Happy New Year ...
Thanks
puppan
healyj
141 Posts
0
November 28th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 31st, 2009 14:00
Try this command (substitute for your interface)
clear counters interface fc 1/15
This e-mail message (including any attachments) is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution
or copying of this message (including any attachments) is strictly
prohibited.
If you have received this message in error, please contact
the sender by reply e-mail message and destroy all copies of the
original message (including attachments).
puppan
36 Posts
0
December 31st, 2009 16:00
HI,
when i executed the above command it shows " invalid command detected at 'c' (clear) .... i executed in the ' config t ' mode.
Please help me in this.
thanks
puppan
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 31st, 2009 23:00
AranH1
2.2K Posts
0
January 4th, 2010 08:00