This post is more than 5 years old
12 Posts
0
34719
#show interface transceiver
Hi..I'm still new with MDS..
Can anyone explain to me what is a primarily indicator/parameter that can show us the SFP replacement is required from #show interface transceiver command?
healyj
141 Posts
0
December 12th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we will set it to “answered.”
Regards,
Jim
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
April 4th, 2011 18:00
Hi,
The show interface transceiver command provides the details of the SFP and will not report if the SFP requires a replacement. Instead you can look out for the commnds like "show module internal exceptionlog" and "show logging log" which provided the error code as below
System Errorcode : 0x4042001e MAC Bit error exceeded threshold
Error Type : Warning
PhyPortLayer : 0x0
Port(s) Affected : 15
The MAC error bit threshold normally specifies an SFP fault and requires a replacement.
Hope this information helps you.
Regards,
Pragna Yeraballi.
Mudzaffar_Ashi1
12 Posts
0
April 6th, 2011 19:00
Hello Pragna,
Thanks for your reply...
By the way, I'm just wondering what is the relevant for the SFP Diagnostics Information output (refer to the bold text) when we run the #show interface transceiver command..
Can you or someone out there explain to me?Especially on the (Optical Tx Power,Optical Rx Power,Tx Fault count,Note: ++ high-alarm; + high-warning; -- low-alarm; -low-warning)
AbhishekKS
71 Posts
0
April 12th, 2011 01:00
Hi,
Please have a look at the following output:-
Here if you notice, you would realize that after the various variables like Temperature, Voltage etc, there is a range of its values given, which can be used as a rekoner to judge the present status of that variable, to be in range or if there is a need to be warned or alarmed. I hope that explains it.