Unsolved
This post is more than 5 years old
302 Posts
1
10023
DD2500 Service Port
Hi, everyone,
I am going to implement DD2500, but I am not sure what Service Port on the back panel of DD2500 is used for. Anyone knows?
Your help would be appreciate in advance.
ble1
14.3K Posts
1
March 19th, 2014 01:00
Does it say Service Port? While I do not have that model, I do not remember seeing anything on my DDs named that way. Two things on that model that you may use apart from standard connections would be IPMI and SOL - I wonder if you are referring to later one.
PeterWirth
14 Posts
0
March 19th, 2014 02:00
Maybe you're looking for the service network port? See attached picture:
bobt5
49 Posts
2
March 19th, 2014 09:00
The network service port is for IPMI management. Also known as a BMC port.
See support.emc.com/kb/183794
t-mat
302 Posts
0
March 19th, 2014 16:00
Hi,
Thank you for your reply. I mean service network port. As you mention, I understand it that is used for IPMI. Thanks.
legard1
8 Posts
0
March 22nd, 2014 01:00
Hi,
May I know if DD2500 have 10GbE-T card? I know that there is onboard 2 x port. But is there a add-on card?
Thanks!
ble1
14.3K Posts
0
March 22nd, 2014 08:00
Check manual (search support for document titled "Installation and Setup Guide" for 2500 system. Following picture gives the hint too (which Peter already shared previously):
You have 3 slots and how you use depends on your model.
legard1
8 Posts
0
March 24th, 2014 23:00
Hi Hrvoje,
I saw from the manual, but as it only mentions for the slots Ethernet, I am not sure if it meant 1G only or 10G for the add-on card. Thought of asking here to see if anyone has implemented 10G cards
Thanks and Regards
Legard
t-mat
302 Posts
0
March 25th, 2014 00:00
Hi,
I am sure that DD2500 has the following onboard NICs on a motherboard, but please let me correct if I make a mistake.
- 10GbE-T card x 2
- 1GbE-T card x 4
Thanks a lot.
legard1
8 Posts
0
March 25th, 2014 01:00
Hi t-mat,
Yes, it does, what I am looking for is the expansion slots. I am intending to add more ports to the DD.
Thanks and Regards
Brighton
PatricJ
1 Rookie
1 Rookie
•
68 Posts
0
March 25th, 2014 08:00
Hi,
you can add three additional IO Modules for FC or Ethernet in Slot 0 to Slot 2
If using mixed then first add Ethernet IO modules before FC. If you add only Ethernet start at Slot 0.
Regards,
Patric
t-mat
302 Posts
0
March 27th, 2014 18:00
Hi,
Sorry for not getting back to you sooner. Thank you for your kind assistance.
Regards,
t-mat