Unsolved
This post is more than 5 years old
1 Message
0
9228
December 21st, 2003 18:00
Cannot find file USBNTMAP.SYS
After a reinstall of ME, when I try to attach my digital camera an error message shows up that says, "cannot find file USBNTMAP.SYS". This is apparently a common problem after ME reinstalls. I have downloaded this file from the internet, but cannot figure out what to do next. How do I install the downloaded file? Cannot figure out how to open or install the file. Thanks for any help.
0 events found
No Events found!
RP-L2
2 Intern
•
617 Posts
0
December 21st, 2003 21:00
This is actually an issue with windows ME when reinstalling USB devices. Check on this link
http://delltalk.us.dell.com/supportforums/board/message?board.id=sw_winme&message.id=25666
OR
Important: Do not exit the wizard.
Click Start, select Search and choose For Files or Folders.
Under Look in, select the computer's hard drive.
Type base2.cab and click Search Now.
Write down the location of the file.
Note: If the base2.cab file was not found on the hard drive, insert the Windows install CD and repeat the above steps to find the file on the CD.
From the Add New Hardware Wizard, click the Browse button.
Locate the base2.cab file you wrote down and click OK.
OR
Download it at www.driverguide.com
egoalter21
1 Message
0
September 5th, 2004 22:00
Insert the Windows Operating System CD...close any boxes that open.
1. Click Start-Run
2. Type MISCONFIG and then click OK
3. Click the Extract button
4. Type in USBNTMAP.SYS and then click Start
5. In the "Restore From" box, type in D:\win9x
6. In the "Save File In" box, type C:\windows\system and then click OK
7. You may be prompted to restart the computer.
Hope this helps!!