XPS 600

Question

I disconnected the power cord on my XPS 600 two clean the inside of the computer   1 Now none of my drives are working DVD roam Drive & DVD burner   The only thing I disconnected was the power cord   Ampzilla

davejohn · Answer

The cables may have become loose when you opened the computer up.  Check all the connections.   Dave

Amused To Death · Answer

The DVD ROM & the DVD+/-RW are working now   1 When I reboot I get this    Drive 1 not found Serial ATM Sata 1  Drive 2 not found Serial ATM Sata 1  Drive 3 not found Serial ATM Sata 1   Gata Primary hard disk drive 0 Failure   Strike F1 key two continue  F10 two run set Up Utility   I think the wide gray cable might have A problem   The Strange thing the computer seems two be working fine After I hit The F1 key   ATD

Amused To Death · Answer

The wide gray cables seem two have become loose when I opened the door I checked them seem fine now     ATD

MaverickmanTP · Answer

Maybe it's time to junk that XPS and get a real computer!!!

davejohn · Answer

MaverickmanTP wrote:

Maybe it's time to junk that XPS and get a real computer!!!

That's helpful.

Try clearing the NVRAM and see if the boot errors stop.

(1) Reset nvram
* Reboot system and enter the BIOS Setup by pressing F2
* Scroll down to Maintenance
* Choose Load Defaults
* Press escape and save the changes

(2) Reset nvram
* Reboot system and enter the BIOS Setup by pressing F2
* Turn on Caps Lock, Scroll Lock and Num Lock
* Press ALT + F (you should hear a beep)
* Press escape and save the changes

Dave

Amused To Death · Answer

Dell Called me and fixed it for me   1 When the Dell screen appears Hit F1 key two enter setup Than go two devices. Turn's out I had those On They should be off 2 Computer working fine now   ATD

Amused To Death · Answer

What no Dell XPS 710   ATD

Locked Topics – Desktops General

XPS 600

Was this post helpful?