@Richgx110 wrote:
I have the power supply! I put the pc in another case because the other got damaged. Please listen carefully. I need to know where to plug in the PWR LED, HDD LED and on off button. Not the power supply stuff. I have it plugged in ok.
look carefully, read carefully.
If its NOT A DELL power supply you will blow up your motherboard.
Or if you do not have a dell power adaptor.
The front panel connector is at the front of the board. Its 9 pin. The on/off/reset power board is also pictured above. Im not going to figure out the wiring for you and its not posted anywhere nor does dell provide this.
I have the power supply! I put the pc in another case because the other got damaged. Please listen carefully. I need to know where to plug in the PWR LED, HDD LED and on off button. Not the power supply stuff. I have it plugged in ok.
Interesting to know how you are going to fit the riser if you are using a non-Dell case and want to use PCI cards......
I would have thought if you were going to use a non-Dell case, you'd be better getting a cheap standard ATX mobo off eBay and using the components of the GX110 in that; been there, done that....its a lot easier than putting a Dell mobo in a standard case!
Message Edited by peterfelgate on 11-07-2005 08:12 AM
It can be done. Its just not for the weak of heart. Just as the Apple G3 and G4 systems can be put into standard cases with custom fittings and panels etc.
speedstep
9 Legend
•
47K Posts
0
November 6th, 2005 13:00
GX110 Power is NOT Standard. :smileysurprised:
You MUST use a DELL 9228C power supply OR use an adaptor.
The front panel connector is a 9 pin connector near the middle front of the board.
ONLY the Adaptor should go to the motherboard No connectors from the PSU should go if you are using a NON DELL power supply.
http://www.endpcnoise.com/cgi-bin/e/dellconverter.html
http://www.impactcomputers.com/8505d.html
The front panel control with intrusion switch/Reset/and on/off looks like this
speedstep
9 Legend
•
47K Posts
0
November 6th, 2005 15:00
look carefully, read carefully.
If its NOT A DELL power supply you will blow up your motherboard.
Or if you do not have a dell power adaptor.
The front panel connector is at the front of the board. Its 9 pin. The on/off/reset power board is also pictured above. Im not going to figure out the wiring for you and its not posted anywhere nor does dell provide this.
Richgx110
3 Posts
0
November 6th, 2005 15:00
peterfelgate_ce40d3
1.3K Posts
0
November 7th, 2005 09:00
Interesting to know how you are going to fit the riser if you are using a non-Dell case and want to use PCI cards......
I would have thought if you were going to use a non-Dell case, you'd be better getting a cheap standard ATX mobo off eBay and using the components of the GX110 in that; been there, done that....its a lot easier than putting a Dell mobo in a standard case!
Message Edited by peterfelgate on 11-07-2005 08:12 AM
speedstep
9 Legend
•
47K Posts
0
November 7th, 2005 17:00
In most all cases its just not worth the effort.
Richgx110
3 Posts
0
November 7th, 2005 19:00
Never mind guys. I'll just bust out the drill, pop me in a few new holes to screw it in there and "GET R' DONE!", thanks for your help ya'll.
PS: I have a fire extinguisher ready! :smileyvery-happy: