Dell Command Configure TPM issue

I have been fighting with enabling, then activating the TPM on an E6420 as part of our SCCM OSD.

After some troubleshooting,the issue comes after running the following command:

cctk --tpm=on valsetuppwd=password

This turns on the TPM without issue, but it also sets the owner at the same time. After a reboot, the activation command fails with the following error:

Note: To set TPM - 1. Admin Password must be set , 2. TPM must not be owned and 3. TPM must be deactivated.

So, for some reason, the CCTK tool is setting an owner on the TPM when it turns it on. Is there a trick to get around this? I am on the latest bios (A21) and using DCC 3.0. This is how I am running these commands:

HAPIInstall.bat

cctk.exe --setuppwd=password

cctk.exe --tpm=on --valsetuppwd=password

Reboot

cctk.exe --tpmactivation=activate --valsetuppwd=password

cctk.exe --setuppwd=  --valsetuppwd=password

It fails during the activation step, because it can't activate with an owner set. I have cleared the TPM, and tested again, and it sets an owner when enabling it every time. How can I enable the TPM without setting an owner?