unable to login to VNX unisphere file simulator

it's always nasadmin/nasadmin , did you deploy single or two datamover version ?

i am running the latest 8.1 and username/password for Unisphere is nasadmin/nasadmin

I have deployed 2 DM, but the creds dont seem to work. what else can be done?

let me give it a shot on 8.1 and would come back if there are any issues

Also the strange thing is that CLI lets me login using both root as well as nasadmin creds , while the UI doesnt

can you help me here?

8.1 also doesnt let me login. Not sure, what is going wrong in the configuration. Need assistance regarding the same.

i just deployed brand new VNX File Simulator single-dual datamover 8.1.0-38015.ova. After configuring an ip address for eth0 i was able to login to Unisphere with nasadmin/nasadmin.

if you are getting to the login prompt, you are past the point of JRE being the issue.

Did you check JRE (Java) version on your system where you are logging-on, whether its compatible with current one or needs higher version ?

Thanx

Rakesh

I have tried the ones which come in .zip files which didnt go through. Working on .ova files to see if gives me a green signal.

I have tried downloading the OVA and however it fails to login with nasadmin creds. Here is a summary of what I did for your reference:

1. Downloaded ova and imported on Vmware workstation 9

2. The setup comes with three nics which shows as bridged, where I have changed eth0 to NAT and the rest to custom (vmnet1 and 2)

3. eth0 was able to pull up the IP from DHCP of vmware and then assigned static ip to it.

4. Changed the host name under /etc/sysconfig/network , updated the DNS on /etc/resolv.conf and added host entries

on /etc/hosts for VNX and my server (2k8r2). Did the same on the window's host to ensure communication.

5. Installed unisphere client(Win-32-x86-en_US-1.0.55.1.0044-1) on the server and it gets to the login screen where it fails.

6. I have similar simulator for Celerra (Celerra VSA 6.0.36.4 - UBERv3.2) from Nikapedia and it lets me login and perform my test absolutely fine.

Please check and let me know where I am going wrong so that I can have this issue resolved.

i am not sure why you are trying to use unisphere client to connect to the simulator, you should be able to use your browser to go to the simulator IP address address.

yeah I do understand...Either ways makes no difference and login does not work . I am preparing a demo for which I wanted to show both , but authentication shouldn't have anything to do with it. Please advice.

This is the ova i use "VNX File Simulator single-dual datamover 8.1.0-38015.ova".