gap between frame and LCD

Question

Hi, I have a CPx J650GT. The screen seems to have a problem: usually the edge of LCD is stuck tightly to the black plastic frame. Now around the downright corner, I can see a gap between the LCD and frame when you looking parallel to the LCD. Actually there is light cylinder over there, while the other 3 side have no this problem. So is my screen falling apart? Now it still works. But will the LCD peel off finally? What should I do to get it fixed? Use some glue to glue them back? Thanks,

funtoupgrade · Answer

Don't glue it and don't worry about it unless it gets worse. If it is really a big deal you could take apart and reassemble the top assembly. It might need a new screen bezel if any of the plastic tabs which hold it in place broke off.

bigworld005 · Answer

Thanks. It is not a big deal now. You won’t see it if you not intentionally to look at a specific angle, not the way when you are working. I think the bezel is fine. Maybe I need to reassemble it. I will find someone to do that because I don’t know where to start. Does someone provide such service in Dallas area?

Regards,

snapohead · Answer

Having someone re-assemble it might be quite pricey. You could do it yourself, here is the service manual ---> http://support.dell.com/support/edocs/systems/pcpxhj/sm/64ptn_en.pdf starting at page 27. You would only need to remove and replace the LCD bezel.

Locked Topics – Laptops General

Was this post helpful?