Failing at Capturing Windows Partition 0%

Question

I'm trying to capture a 1703 UEFI image.  I used Hyper-V to create the image.  Everything runs fine until it reboots into the WinPE environment and tries to capture the Windows partition.  It then gets stuck at 0% and never progresses.  I can't get to any logs by pressing F8, it just hangs there forever.  I'm stumped, any ideas?

ed_goldberg · Answer

Please compare your settings in the session with the settings in the tutorial through the link listed below.

minnesberg · Answer

Hi. Did you manage to solve this issue ? I am experiencing the same thing, thanks !

oszphill · Answer

Hi there Did you get the solution? I have the same situation.

Daniel Quadrini · Answer

It could be that the virtual machine was created with less than the recommended settings, like a hard disk smaller than 100 Gb. Also check if you're using the latest ImageAssist tool version.

Image Assist

Was this post helpful?