Unsolved

This post is more than 5 years old

Closed

3 Posts

20109

January 17th, 2007 10:00

Latitude CPx

I have this old Dell Latitude CPX. It will not show any video or boot. I have taken the keyboard out and found that some card that is attached to the motherboard by screws has a burned chip. The card has a plastic covering that had a melted spot. Now I have removed that card trying to get some info off of it. I can't seem to figure out what it does. After some research, it seems that it may be some sort of voltage regulator card. Can anyone shine some light on this?

3 Posts

January 17th, 2007 22:00

It seems that my other thread got deleted because I included my ST number. It was deleted before I got to read a post that someone posted.  I could really use your help again. Thanks...

4.4K Posts

January 18th, 2007 03:00

Can you post a picture of what you are talking about?  That might help to identify the component in question.
 

2 Intern

 • 

4K Posts

January 18th, 2007 04:00

I believe this is what you are looking for. It is a Power Board. I bought a CPx board
with the same burnout problem on that board. D P/N is 0502U

Message Edited by leduke30 on 01-18-200712:27 AM

3 Posts

January 18th, 2007 11:00

That is it...You are a life saver.
 
Thanks so much!!

1 Message

September 12th, 2007 03:00

Hi, need help. I have Dell Latitude Cpx model No. PRX, "Latitude C Family".  I push the power button, the hard drive light comes on for a second, the screens back lighting comes on, and then everything just turns off. The battery charging light stays on though. Don't know what to do, do I need to take the computer apart? Does this sound similar to your power board problem.  Anything will be appreciatied. Thankyou. 

2 Intern

 • 

4K Posts

September 12th, 2007 05:00

Try using your RAM modules one at a time in both slots singly and see if it will boot with any configuration. The CPxH/J, the CPtV/S and Inspiron 3700/3800 series all use the same mainboards and all are prone to develop Bad RAM slots. If no joy there, try reseating the CPU/Integral circuit board next. If that is unproductive, you can then obtain a Power Board and try it; the first two checks will cost nothing to try first before you spend money on a power board.

1 Message

April 28th, 2008 17:00

I have the same problem, but it seemed to work for a while if I would open and close the top, no it will not boot at all. Some had said it is the magnetic switch, if this is true how would I fix or dissable the switch?
No Events found!

Top