You can also release flea power and run hardware diagnostics in the system to check the hardware is working as designed. Follow the steps below.
Switch off the system; remove the battery, ac adapter and the power cable. Press and hold down the power button for thirty seconds to drain any excess flea power and run the test. Please run the PSA hardware diagnostics to check if the hardware is working as designed. Follow the steps below.
Turn the computer off >restart the computer
At the Dell logo screen, start tapping the F12 key a few times until you see the ‘One Time Boot Menu’ appear.
At the one time boot menu, press the down arrow key to highlight ‘Diagnostic’, and then press Enter to begin the PSA diagnostics.
If the test fails, please make a note of any error codes listed. You can also refer to the link below.
DELL-Senthil S
4 Operator
•
2.5K Posts
0
January 1st, 2013 05:00
Hi rusalka2711,
You can also release flea power and run hardware diagnostics in the system to check the hardware is working as designed. Follow the steps below.
Switch off the system; remove the battery, ac adapter and the power cable. Press and hold down the power button for thirty seconds to drain any excess flea power and run the test. Please run the PSA hardware diagnostics to check if the hardware is working as designed. Follow the steps below.
Turn the computer off >restart the computer
At the Dell logo screen, start tapping the F12 key a few times until you see the ‘One Time Boot Menu’ appear.
At the one time boot menu, press the down arrow key to highlight ‘Diagnostic’, and then press Enter to begin the PSA diagnostics.
If the test fails, please make a note of any error codes listed. You can also refer to the link below.
http://dell.to/i5zbDR
Please do reply for further assistance.