Unsolved
This post is more than 5 years old
1 Rookie
•
48 Posts
0
552
March 3rd, 2019 08:00
IN1910Nf, base, adjustable stand?
This monitor has a non-adjustable base mounted low. You can tilt the screen but not raise it. But it looks like the monitor also has the mounting area higher up for a sliding base so that you can mount the Dell sound bar. Is there a part number for the height adjustable foot?
Thanks!
0 events found
No Events found!
DELL-Chris M
Community Manager
•
56.9K Posts
•
232.1K Points
0
March 3rd, 2019 11:00
Dell never tested any other stands on this 2009 monitor. It does offer the standard VESA 100mm mounting holes (page 4) behind the attached base plate. So any universal VESA stand with 100mm holes/screws might work.
RoscoePColtrane
1 Rookie
•
48 Posts
0
March 3rd, 2019 19:00
Thanks, there is definitely a square mounting hole dead center in the back of the monitor that must be used for mounting and it has the tabs for the AX510 soundbar at the lower edge of the screen. You have to remove the existing foot in order to mount a soundbar so you would need a different foot that attached higher up.