Unsolved
This post is more than 5 years old
12 Posts
0
20070
Dell PowerConnect 62XX Storm Control Configuration
Hi,
I've been having some troubles with broadcast storms on my company's VOIP network (whichs is isolated from the rest physically). I wanna know how I should configure storm-control on my Dell PCT6224 and 6248 so that the switches can block any overflow of broadcast packets.
But I have a doubt about the value I should use. Here is what the switch help command say: "Enter the storm-control threshold as percent of port speed. Percent of port speed is converted to PacketsPerSecond based on 512 byte average packet size and applied to HW..."
I wonder if my calculations are right:
The ports in which the config will be applied are all in 1Gbps. So if I want to put a 1% threshold the switch will convert to (1000000000*0.001) / (512*8) ~= 2441.4 pps.
My network runs on a 0.39 pps when its operating correctly so it wont interfere on the normal broadcast traffic.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
November 16th, 2015 13:00
That looks good to me, I get the same result. You should be able to enter the value as a percent though.
console(config-if-1/g1)#storm-control broadcast level 1
Is the VOIP traffic on the same VLAN as the rest of the network?
MauricioUsatai
12 Posts
0
November 17th, 2015 03:00
Thank you very much for the answer!
Actually, the VOIP traffic runs on a decoupled network (yeah thats right - we've got two different networks for data and voice).
Hope it solve the problem.