Unsolved
7 Posts
0
1583
Switch S4048T-ON- Communication between VLANS
Hello everyone,
I would like to have a doubt. I have in my network two s4048T-ON switch configured in LACP mode, with 3 VLANS being one of them the vlan default (this already communicates normal) with the same names in both, how could I configure for VLANS to communicate with each other?
Switch 1 VLAN default VLAN 10 VLAN 20
Switch 2 VLAN default VLAN 10 VLAN 20
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
September 25th, 2018 11:00
Hello
For a switch to route traffic across VLANs there are typically two configuration options that need to be enabled. You need to enable routing at a global level on the switch, and you need to enable routing on the VLAN. You should be able to find more information on performing these actions in the system manual on the switch support page.
http://www.dell.com/support/
Thanks
jroberto1987
7 Posts
0
September 25th, 2018 12:00
Hi Daniel,
I have little experience with these switches, I looked at the manual even though I was lost, what I want is to communicate the vlans of switch 1 with switch 2 being that these vlan were in the same network.
Could you walk the steps of how do I do this?
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
September 25th, 2018 12:00
This article has examples of routing VLANs. The command syntax may vary between switches, so you should reference the guides for your switch if there are syntax errors.
https://www.dell.com/support/article/sln294670/
jroberto1987
7 Posts
0
September 26th, 2018 15:00
Hello Daniel, actually I do not want to routing between the vlan I would like to know how I do the trunk in portchannel, could I pass the commands?