Unsolved
This post is more than 5 years old
1 Rookie
•
65 Posts
0
3770
June 9th, 2017 03:00
sflow on S4048-ON
I m trying to configure sflow on my S4048-ON on all interface but when in interface modei ran
sflow enable
interface tengigabitethernet 1/15
sw-cns-coeur-ng(conf-if-te-1/15)#sflow enable
% Error: Te 1/15 Port is not in default mode.
this interface is in a port channel
should i enable sflow in the port channel?
No Events found!
DELL-Josh Cr
Moderator
•
9.4K Posts
0
June 9th, 2017 13:00
Hi,
Yes, do it on the port channel so it captures all of the packets.
EricDoutreleau
1 Rookie
•
65 Posts
0
June 11th, 2017 09:00
Thanks i did that
but i got no sflow exported
show sflow
sFlow services are enabled
Egress Management Interface sFlow services are disabled
Global default sampling rate: 512
Global default counter polling interval: 30
Global default extended maximum header size: 128 bytes
Global extended information enabled: none
1 collectors configured
Collector IP addr: 172.23.225.30, Agent IP addr: 172.24.112.5, UDP port: 6343 VRF: Default
0 UDP packets exported
8467 UDP packets dropped
9012 sFlow samples collected
stack-unit 1 Port set 0
Te 1/2: configured rate 512, actual rate 512
Te 1/5: configured rate 512, actual rate 512
Te 1/6: configured rate 512, actual rate 512
Te 1/7: configured rate 512, actual rate 512
Te 1/8: configured rate 512, actual rate 512
Te 1/9: configured rate 512, actual rate 512
Te 1/12: configured rate 512, actual rate 512
Te 1/14: configured rate 512, actual rate 512
Te 1/15: configured rate 512, actual rate 512
Te 1/16: configured rate 512, actual rate 512
Te 1/20: configured rate 512, actual rate 512
Te 1/21: configured rate 512, actual rate 512
Te 1/22: configured rate 512, actual rate 512
Te 1/23: configured rate 512, actual rate 512
Te 1/24: configured rate 512, actual rate 512
Te 1/25: configured rate 512, actual rate 512
Te 1/26: configured rate 512, actual rate 512
DELL-Josh Cr
Moderator
•
9.4K Posts
0
June 12th, 2017 10:00
Just on the port channel or any of the interfaces? It shows that is is collecting from that output.
DELL-Josh Cr
Moderator
•
9.4K Posts
0
June 12th, 2017 15:00
Is the ip address that it is exporting to reachable?
EricDoutreleau
1 Rookie
•
65 Posts
0
June 12th, 2017 15:00
Yes it s collecting
but it s exporting nothing
i have 0 udo packet exported
EricDoutreleau
1 Rookie
•
65 Posts
0
June 15th, 2017 03:00
Yes it s reeachable.
the same server can get snmp info from the switch
DELL-Josh Cr
Moderator
•
9.4K Posts
0
June 15th, 2017 11:00
Is this the only switch being collected or can that server collect from other switches fine?