The SMPS is on my bench right now. I am not sure from what model of server it was removed. I was asked to test the SMPS itself. As I understand, this SMPS requires a logic level LOW to be applied to one of its pins (REMOTE SENSE) in order to be turned on. I simply need to know hich pin should be LOW.
Unfortunately, Dell support here does not have such information. Normally such tests are not required to determine if the power support is operational.
On a side note, D1300EF-02 is used in Dell Precision Workstations. I suggest to ask questions related to the workstations on a board dedicated to them:
https://dell.to/2IJXUV6
DELL-Joey C
Moderator
Moderator
•
3.1K Posts
0
May 18th, 2020 19:00
Hi,
On what system is the power supply from? Are you inquiring on workstation?
santon74
2 Posts
0
May 19th, 2020 01:00
The SMPS is on my bench right now. I am not sure from what model of server it was removed. I was asked to test the SMPS itself. As I understand, this SMPS requires a logic level LOW to be applied to one of its pins (REMOTE SENSE) in order to be turned on. I simply need to know hich pin should be LOW.
Thanks,
Anton.
DELL-Joey C
Moderator
Moderator
•
3.1K Posts
0
May 19th, 2020 01:00
Hi,
Unfortunately, I don't have much information about the pin out of the mentioned D1300EF-02.
Darkstar
1 Message
0
October 16th, 2020 19:00
Same problem. Can't seem to locate any diagrams. No motherboard to trace back to.
DELL-Joey C
Moderator
Moderator
•
3.1K Posts
0
October 19th, 2020 00:00
Hi,
Unfortunately, Dell support here does not have such information. Normally such tests are not required to determine if the power support is operational.