E2113 error is indicating that the memory mirroring is having an issue.
Could you check in BIOS under Memory settings, if the mode is set to mirroring or optimized?
There are a few things which are not known to me, could you let me know in the original R710 memory slots, what slots are installed initially? Is the BIOS on most updated version? What memory is installed in Slot B3?
If you would like to check if the memory is having issues or the slot it self, bring the server to minimum post condition:
System board
Risers
Processor (CPU1) with Heatsink
Power Supply
One stick of memory in dual in-line memory module (DIMM) slot A1
Control Panel with cable
Then clear the logs in BIOS. If you're having the same error, then the motherboard is faulty. If there is no error, install the memory in pairs 1 by 1.
Yea seems its an issue with the MB then. Other than the warning in the front LCD i see no other issues with the system and its operation. Can i turn off this check in anyway so its not showing up every time i start the system. Having to go into iDrac and reset the logs every start up.
DELL-Joey C
Moderator
•
4.1K Posts
0
December 3rd, 2019 23:00
Hi,
E2113 error is indicating that the memory mirroring is having an issue.
Could you check in BIOS under Memory settings, if the mode is set to mirroring or optimized?
There are a few things which are not known to me, could you let me know in the original R710 memory slots, what slots are installed initially? Is the BIOS on most updated version? What memory is installed in Slot B3?
If you would like to check if the memory is having issues or the slot it self, bring the server to minimum post condition:
Then clear the logs in BIOS. If you're having the same error, then the motherboard is faulty. If there is no error, install the memory in pairs 1 by 1.
TheFallout
3 Posts
0
January 9th, 2020 22:00
Yea seems its an issue with the MB then. Other than the warning in the front LCD i see no other issues with the system and its operation. Can i turn off this check in anyway so its not showing up every time i start the system. Having to go into iDrac and reset the logs every start up.