E1000 Error on Front LCD, Failsafe, Call Support on PE-2850

Question

Hi,   Just install New Server PowerEedge 2850 , after install 3 days on Front LCD Messege was apper (E1000, Failsafe, Call support) I never saw this type of error before.   Now server is not booting even I remove one PowerSupply, ROM Key + Memory, SCSI cable of backplane, Remove HDD & CD-ROM, change the memory.  So please guide what I have to do now.  Even I can not run dignostic software because server is not booting.   Regards Asim

Mark_A_Smith · Answer

Call Dell Support.

yarddawg7 · Answer

Have to bump up an old thread as we just ran into the same problem.  I plan on calling Dell tomorrow, but is this a known problem?  Is there any additional information out there?

shkasim · Answer

Soluation of this problem change the motherboard

PowerEdge Hardware General

E1000 Error on Front LCD, Failsafe, Call Support on PE-2850

Was this post helpful?