Unsolved
This post is more than 5 years old
2 Posts
0
5766
June 15th, 2004 18:00
Errors on bootup for PowerEdge 8450
During the bootup process I receive the following two errors before it reachs the Windows 2000 splash screen:
8401: Hot plug switches overidden by jumper or setup.
And
ERROR
8155: System Event Logging is full.
Where can I check System Event Logging for the BIOS and should I be concern about the first error?
Thanks
No Events found!
Tariq Syed
32 Posts
0
June 29th, 2004 06:00
For the first error that you mentioned, there are switches called "DIP Switches" on the I/O Board where your PCI slots are. Look at this page below for graphics:
On Switch Position # 7, make sure it is set to Open. Open is the default position, the link above shows "Closed" as being default position which is not correct.
Message Edited by Tariq Syed on 06-29-2004 02:24 AM
phcahill
38 Posts
0
July 17th, 2005 13:00