Unsolved
This post is more than 5 years old
1 Message
0
11792
I HAVE BIOS MIRROR WITH TWO SATA HARDISK DRIVES USING adaptec serial ata raid 2410sa RAID CARD
I HAVE DONE BIOS MIRROR WITH TWO SATA HARDISK DRIVES USING ADAPTEC SERIAL ATA RAID 2410SA RAID CARD IN ONE SINGLE ARRAY. I INSTALLED MS WINDOWS 2003 R2 EDITION IN 00 SATA HARDISK. ONE HARDISK OF THIS ARRAY BECAME FAULTY, I HAVE TO REPLACE HARDISK HARDISK, THESE TWO DRIVES DOSE`T SUPPORT HOT SWAP. HOW CAN I DO THAT.
REGRADS
PRAMOD INGOLE
DELL-Geoff P
990 Posts
0
April 26th, 2012 07:00
Here is a link for the Adaptec manual: download.adaptec.com/.../aar2410Sa_iug.pdf
Power down the server, replace the failed drive. Enter the Ctrl A bios. You will need to add the new drive as a hotspare, then once its finished, it should take its place in the array.
Regards,