Installing Netware 5.1 on a PowerEdge 800 and SATA driver won't load

I am trying to install Novell Netware 5.1 on my new PE800 and when I get to the storage drivers section of setup, I plug in the AARICH.HAM driver (as dell has supplied from the drivers section) and netware then asks for the port it is installed on.  I have looked and the port tells me 10012, 10014, 10016 and 10019 depending on the IRQ in bios that I choose.  The problem is that no matter which one I choose, it fails to load.  It tells me that the device failed to load and it may be disabled.  I know the device isn't disabled because I am booting a DOS partion from it before I start the installation.

 

Any ideas would be greatly appreciated.

 

BTW...I have even downloaded the Service Pack 8 from novell to get the latest AARICH.* files with no luck.

 

Thanks

Doug