Unsolved
This post is more than 5 years old
11 Posts
0
13097
M610 - IDRAC
Hi All,
Having a problem with accessing the blade from the enclosure. M610 blade, i need the part number for the IDRAC6 VFLASH as it wasnt in the blade when supplied.
I cannot connect to the blade from the enclosure as i think this is missing?
Any help would be great.
Thanks
DELL-Manfred W
Moderator
Moderator
•
166 Posts
0
January 4th, 2012 23:00
Hi storto1
I'm so sorry to hear that you are having some problem with the M610.
Basically have you check physically that the IDRAC6 VFLASH card is missing?
Here's a hardware manual to check the VFLASH card physically.
Please refer to page 225
support.us.dell.com/.../HOMen.pdf
If you confirmed the VFLASH card is missing, do provide me your service tag of M610 so that I can provide you the part number for the VFLASH card.
MW@DeLL
twitter.com/DellProSupport" Support on Twitter @DellProSupport
storto1
11 Posts
0
January 5th, 2012 14:00
Hi,
Thanks for the quick reply.
I am missing:
1 SD vFlash card in upper card slot
2 iDRAC6 Enterprise card
Do i need the Vflash card?
Service tag = <ADMIN NOTE:Service tag removed per privacy policy>
Thanks again.
DELL-Manfred W
Moderator
Moderator
•
166 Posts
0
January 8th, 2012 21:00
Hi storto1
I have actually done a simulation on a test unit M610 and even without the VFLASH card, I can still remote access the blade.
Please email me your service tag, as it was blocked.
My email is manfred_wong@dell.com
MW@DeLL