P4600 - No microcode update loaded for processor 1 and 2

Question

Hi There:I just replaced a P4600 media bay that is set up as a Raid 1 and has my windows server OS.  All cables are connected correctly and tight.  I use an anti-static apron so there was no chance that the motherboard got zapped. When I rebooted, I got the following error from both processors: 'Warning! no microcode update loaded for processor 1 &2' (actually two messages - 1 for each processor) I'd use Open Manage to load the bios, but if the processors won't start, what do I do? Thanks Update: I swapped out the CPUs and I get the same message!!! The PERC3/DI shows all drives, and F2 shows the CPUs descriptions just fine.

M_6 · Answer

mcolman, Try flashing the Bios - it should be A13. M@l

mcolman · Answer

Thanks M@I. It worked like a charm. A13 was already in there, but I overwrote it, and the messages went away. Mucho Thanks

PowerEdge Hardware General

Was this post helpful?