Unsolved
This post is more than 5 years old
1 Message
0
7381
June 12th, 2008 19:00
PowerEdge 2160AS gives bad display
I have a PowerEdge 2160AS KVM switch connected to a rack console and i get a really bad display. It seems to be the refresh rate since its a little fuzzy and seems to scroll a little the way it would if the refresh rate was low. I didnt see anything in settinngs that seemed to point to a solution. I dont think its the console because I connected the console directly to one of the servers and it seemed to display fine. I updated the firmware for the switch just in case that was the issue.
Any ideas?
No Events found!
snapohead
1.2K Posts
0
June 13th, 2008 04:00
JM_MD
18 Posts
0
October 21st, 2009 09:00
I have just encountered a similar issue. The display is completely "fuzzy". The image is bad on both A and B ports of the KVM. I've switched monitors just to be sure and the image is unchanged. The unit is out of warranty so I guess I'll need to order another one.