You figure this out? i have a unit giving same on Bank2-B, but no DIMM there and i have cleared the logs. Well i think i have, i read you just power the unit down, unplug it from power souce for 30 sec and it will do that... doesn't really seem to have worked... I want to pop the onboard battery just to see (not the RAID)... doesn't really matter to me what i gain or lose with that because i do not have an OS installed or containers setup so i doubt i would hose anything but the date/time in the bios.

I actually just gave up and tossed in the ERAC (Embedded Remote Access Card P/N R0299), updated it's firmware, used the CTRL+D at boot to access it's config and give it a good IP address/gateway and then logged in via standard https/browser using the IP i just setup. I was able to clear the logs in no time via that. If you do not use a ERAC, buy one off eBay and use it! might as well so that Utility NIC get's used... plus the interface/embedded web administration is great, as-is the console redirection. Totally worth the $20-50 bucks.