Poweredge 2950 II vs III

Question

Hello, I'm thinking of picking up an PE 2950 to use for a number of purposes.  A storage server, and virtulization for home use.  Before I go into my question I just want to say I am aware this is an older server, and can be quite loud - neither of these are an issue as the server has its own area it will be stored with adequate cooling and noise isn't an issue is this area.  Out of sight, out of mind. My question is: A: What is the difference between the PE2950 II and the PE2950 III?   B: If I were to pick up a 2950 II would I be able to upgrade the processors to dual Xeon E5440 or E5550?   I have the opportunity to pick up a PE2950 II for around $150 but it has Xeon E5320's in it and I'd like to push the processing power a little higher. thanks for your assistance!

theflash1932 · Accepted Answer

I'm not aware of any specific restrictions on specific processors from a supported series, so they should.

theflash1932 · Answer

There is very little difference between the II and III, but most importantly, the processors supported differ (below). Both support 64GB of RAM, and I believe both support 1333MHz FSB, TOE, and TPM (that sets them apart from version I, as it supports only 32GB RAM and 1066MHz, with no TOE or TPM).

5400-series processors can be installed on the 2950 III only (rI-5100, rII-5300, rIII-5400).

5500-series processors are not suppported on any version of the 2950.

sapper6fd · Answer

So the 2950 II will accept say a Xeon X5355 or an X5365?

PowerEdge Hardware General

Was this post helpful?