It could just be an issue of OMSA not properly updating the status after the drive replacement. If the status persists after the rebuild is complete then restart the OMSA services. If that does not clear the status then it may persist until a system restart.
You should also check to make sure OMSA doesn't have a driver or firmware update listed as required. If a driver or firmware update is available for a backplane or controller it will produce warning messages in OMSA.
Daniel My
10 Elder
•
6.2K Posts
0
October 20th, 2017 10:00
Hello
It could just be an issue of OMSA not properly updating the status after the drive replacement. If the status persists after the rebuild is complete then restart the OMSA services. If that does not clear the status then it may persist until a system restart.
You should also check to make sure OMSA doesn't have a driver or firmware update listed as required. If a driver or firmware update is available for a backplane or controller it will produce warning messages in OMSA.
Thanks